ESP32-Based Semi-Humanoid Welcome Robot with Voice Greeting, Visual Display and Image Storage Using Raspberry Pi 4
Authors
Final-year B.E. Students, Department of Electrical and Electronics Engineering, K. Ramakrishnan College of Technology (Autonomous), Samayapuram, Tiruchirappalli, Tamil Nadu (India)
Final-year B.E. Students, Department of Electrical and Electronics Engineering, K. Ramakrishnan College of Technology (Autonomous), Samayapuram, Tiruchirappalli, Tamil Nadu (India)
Final-year B.E. Students, Department of Electrical and Electronics Engineering, K. Ramakrishnan College of Technology (Autonomous), Samayapuram, Tiruchirappalli, Tamil Nadu (India)
Final-year B.E. Students, Department of Electrical and Electronics Engineering, K. Ramakrishnan College of Technology (Autonomous), Samayapuram, Tiruchirappalli, Tamil Nadu (India)
Assistant Professor (SG), Department of Electrical and Electronics Engineering, K. Ramakrishnan College of Technology (Autonomous), Samayapuram, Tiruchirappalli, Tamil Nadu (India)
Article Information
DOI: 10.51583/IJLTEMAS.2026.151000118
Subject Category: Robotics and Automation Engineering
Volume/Issue: 15/10 | Page No: 1464-1479
Publication Timeline
Submitted: 2026-10-28
Accepted: 2026-11-02
Published: 2026-11-17
Abstract
This paper presents the design of a semi-humanoid welcome robot that greets people by voice, shows what its camera sees and stores the captured images for later reference. A Raspberry Pi 4 Model B is the main processing unit. It handles the microphone and speaker for voice greetings and coordinates the other parts of the robot. An ESP32 microcontroller is the secondary controller. It drives the servo motors for head and hand gestures and the 30 RPM DC motors of the base through an L298N motor driver, while an ESP32-CAM captures images that are shown on a visual display and can be saved. A 12 V, 18 Ah battery supplies the robot, and a buck converter lowers the voltage for the Raspberry Pi and the other electronic parts. An ultrasonic sensor stops the motors when an obstacle comes within 30 cm. The functions and communication links of each processing unit are defined, and the drive, power budget, battery, obstacle limit and servo torque were sized by design calculations. The calculated robot speed is about 0.102 m/s, the estimated load is 37.5 W, and the 216 Wh battery can theoretically run the system for about 5.76 h (about 5.4 h when an assumed 85 % converter efficiency is included). Fault-handling provisions and measures for protecting stored images and personal data are proposed, and a measurement protocol for voice response time, image acquisition, communication latency, movement accuracy and power consumption is given; measured values are not yet reported. The robot is low in cost, modular and easy to extend, and it suits reception desks, laboratories, offices and exhibitions.
Keywords
Semi-humanoid robot, Raspberry Pi 4, ESP32, ESP32-CAM, voice greeting, visual display, L298N motor driver, human–robot interaction, data privacy
This article is licensed under a Creative Commons Attribution 4.0 International License (CC BY 4.0).
Downloads
References
1. F. B. Eylidarson, Yulkifli, and M. B. Sari, “An image processing-enabled humanoid robot for autonomous guest reception using ESP32-CAM,” Research on Instrumentation, 2025. [Google Scholar] [Crossref]
2. J. Floersch and P. Y. Li, “Human gesture robot control using a camera/accelerometer-in-palm sensor,” IFAC-PapersOnLine, vol. 54, no. 20, pp. 284–289, 2021. [Google Scholar] [Crossref]
3. IEEE, “AURA: Advancing human-robot interaction through unified voice and gesture control,” in 2025 8th International Conference on Electronics, Materials Engineering & Nano-Technology, 2025. [Google Scholar] [Crossref]
4. Martínez, Martínez, and Penagos, “Integrating low-cost vision for autonomous tracking in assistive robots,” Bulletin of Electrical Engineering and Informatics, 2025. [Google Scholar] [Crossref]
5. D. P. Rajgade, “Design and development of an AI-powered multimodal humanoid robot (AI Bot) with integrated audio-visual intelligence and internet-based knowledge retrieval,” International Journal for Multidisciplinary Research, vol. 7, no. 4, 2025. [Google Scholar] [Crossref]
6. Raspberry Pi Ltd, Raspberry Pi 4 Model B Datasheet, 2024. [Google Scholar] [Crossref]
7. N. Robinson, B. Tidd, D. Campbell, D. Kulić, and P. Corke, “Robotic vision for human-robot interaction and collaboration: A survey and systematic review,” ACM Transactions on Human-Robot Interaction, vol. 12, no. 1, Art. 12, 2023. [Google Scholar] [Crossref]
8. S. Syjan, H. T. Jaradath, and V. C. Shetty, “AI-driven humanoid animatronic face for real-time multimodal human-robot interaction,” in 2026 IEEE International Conference on Emerging Synergy Science and Technology, 2026. [Google Scholar] [Crossref]
9. “Multimodal sentiment analysis applied to interaction between patients and a humanoid robot Pepper,” IFAC-PapersOnLine, vol. 52, no. 27, pp. 411–414, 2019. [Google Scholar] [Crossref]
10. “A surveillance based interactive robot,” arXiv, 2025. [Google Scholar] [Crossref]
This work is licensed under CC BY 4.0